Reclaimed rubber EPT
Feature and Construction
one. This is a double roll rubber-miXiHu (West Lake) Dis.ng EPT. It is made up of motor, gear-down EPT, driving gears, pace-ratio gears, front and again rolls, bearings, frame, go over, bed plate, changing pin unit, crisis cease unit, roll temperature changing unit, lubricating device and content plate, and many others.
two. Entrance and again rolls are pXiHu (West Lake) Dis.Hu (West Lake) Dis.lel mounted in the bearing of frame. By signifies of EPT, driving gears, velocity ratio gears, the motor drives the entrance and again rolls rotate towards each and every other so that rubber-cracking is begun. The rolls are manufactured from chilled cast alloy iron The internal of it is hollow. Steam and cooling drinking water can go via them so that the surface temperature can be modified. Its area possesses greater hardness and fineness.
three. Roller bearing, copper bushing is mounted in the bearing foundation of frame. Back roll bearing bases are fixed up on body, and the entrance roll-bearing foundation can slide in the XiHu (West Lake) Dis.Hu (West Lake) Dis.-rail of frame.
4. Roll spacing changing is carried out by implies of the reverse of hand wheel helps make the thread rod travel front bearing foundation movement. The roll pin lowers when the hand wheel rotates clockwise, in any other case it will increase.
five. The crisis stopping system is mounted in the frame. In abnormal predicament, pulling the rod, by way of dynamic, the EPT is stopped immediately.
six. Adjusting temperature system is two spray pipes with numeral rows of holes, increase the two pipes into the hollow roll, the holes are in the place of functioning section of the roll. The position of holes slants to thirty diploma interior path so that the spraying h2o and steam is directed at getting in touch with angle of sizing substance, this can manage the surface area temperature of roll.
|Front roll diameter(mm)||400||450||560|
|Rear roll diameter(mm)||four hundred(Groove roller)||450(Groove roller)||510(Groove roller)|
|Functioning size of rolls(mm)||600||650||800|
|Entrance roll floor velocity(m/min)||seventeen.32||23.two||24.56|
|Motor EPT||forty five||55||75|
|Total dimension: duration timesWidth timesHeight(mm)||3950 times1800 times1780||4770 times1846 times1835||5064|